
B-64120EN/01 4.DESCRIPTION OF PARAMETERS
- 269 -
NOTE
1 When parameter No.5314 is set to 0, the setting of
parameter No.5310 is used. When parameter
No.5314 is set to a value other than 0, parameter
No.5310 is disabled; in this case, the setting of
parameter No.5314 is used.
2 When rigid tapping is performed using the second
spindle
• When the SPR parameter (bit 1 of parameter
No.5204) is set to 0, the setting of parameter
No.5314 (or No.5310) is applied to the second
spindle, as well as to the first spindle.
• When the SPR parameter (bit 1 of parameter
No.5204) is set to 1, the setting of parameter
No.5350 is applied to the second spindle,
respectively.
Spindle backlash in rigid tapping (first-stage gear)
5321
Spindle backlash in rigid tapping
Spindle backlash in rigid tapping (second-stage gear)
5322
Spindle backlash in rigid tapping (third-stage gear)
5323
Spindle backlash in rigid tapping (fourth-stage gear)
5324
Spindle backlash in rigid tapping using the second spindle (first-stage gear)
5325
Spindle backlash in rigid tapping using the second spindle (second-stage
gear)
5326
[Data type] Byte
[Unit of data] Detection unit
[Valid data range] 0 to 127
Each of these parameters is used to set a spindle backlash.