
B-64120EN/01 4.DESCRIPTION OF PARAMETERS
- 215 -
NOTE
This parameter is used to output the inter-spindle
phase error detection signal SYCAL in the serial
spindle synchronization control mode. The SYCAL
<F044#4> signal becomes "1" when a phase error
exceeding the value set in this parameter is found.
Master spindle under synchronous spindle control
4812
Slave spindle under synchronous spindle control
4813
[Data type] Byte
[Valid data range] 0, 1, 2
Set the master spindle and slave spindle in spindle synchronization
control.
Setting value : 1 to 2, First to second spindles
NOTE
These parameters are valid only in spindle
synchronization control specified by programming.
If 0 is set, turning on spindle synchronization
control by programming (G51.8) results in an
alarm.
4831 Master axis of first spindle under synchronous spindle control
4832 Master axis of second spindle under synchronous spindle control
NOTE
When these parameters have been set, the power
must be turned off before operation is continued.
[Data type] Byte
[Valid data range] 1 to Number of spindles
Set the slave axis and master axis of synchronous spindle control by
spindles. Set the axis number of the master axis for the axis to be
handled as the slave axis.
NOTE
This parameter is valid if bit 4 (SSS) of parameter
No. 3704 is set to 1.