B-64120EN/01 4.DESCRIPTION OF PARAMETERS
- 235 -
4.22 PARAMETERS OF CANNED CYCLES
4.22.1 Parameter of canned Cycle for Drilling
#7 #6 #5 #4 #3 #2 #1 #0
M5T ILV RTR FXY
5101
M5B M5T RD2 RD1 EXC FXY
[Data type] Bit
FXY The drilling axis in the drilling canned cycle is:
0 : Always the Z-axis
1 : The axis selected by the program
NOTE
In the case of the T series, this parameter is valid
only for the drilling canned cycle in the FS10/11
format.
EXC G81
0 : Specifies a drilling canned cycle
1 : Specifies an external operation command
RTR G83 and G87
0 : Specify a high-speed peck drilling cycle
1 : Specify a peck drilling cycle
ILV Initial point position in drilling canned cycle
0 : Not updated by reset
1 : Updated by reset
RD2, RD1 Set the axis and direction in which the tool in drilling canned cycle
G76 or G87 is got free. RD2 and RD1 are set as shown below by
plane selection.
RD2 RD1 G17 G18 G19
0 0 +X +Z +Y
0 1 -X -Z -Y
1 0 +Y +X +Z
1 1 -Y -X -Z
M5T When a spindle rotates from the forward to the reverse direction and
vice versa in tapping cycles G84 and G74 for M series (G84 and G88
for T series), before M04 or M03 is output:
For T series
0 : Not output M05
1 : Outputs M05
For M series
0 : Outputs M05
1 : Not output M05
M5B In drilling canned cycles G76 and G87:
0 : Outputs M05 before an oriented spindle stops
1 : Not output M05 before an oriented spindle stops