
4.DESCRIPTION OF PARAMETERS B-64120EN/01
- 226 -
#7 #6 #5 #4 #3 #2 #1 #0
TLE QNI PRC CNI
5005
[Data type] Bit
CNI On the offset screen, Y-axis offset screen, and macro screen, the
[INP.C] soft key is:
0: Used.
1: Not used. (The [INP.C] soft key is not displayed.)
PRC Direct input of tool offset value and workpiece coordinate-system
shift value
0 : Not use a PRC signal
1 : Uses a PRC signal
QNI In the function of input of offset value measured B
0 : Not automatically select the tool offset number
1 : Automatically selects a tool offset number
TLE When the tool offset measurement value direct input B function is
used, a tool offset value, set by the offset write signal, is:
0 : Always received in offset write mode.
1 : Received only in offset write mode and during movement along
an axis (where "during movement along an axis" means that the
positional deviation value is other than 0).
#7 #6 #5 #4 #3 #2 #1 #0
TGC OIM
5006
TOS TCE OIM
[Data type] Bit
OIM When the unit is switched between the inch and metric systems,
automatic tool offset value conversion is:
0 : Not performed
1 : Performed
NOTE
If this parameter setting is changed, reset the tool
offset data.
TGC When a T code is specified in a block containing G50, G04, or G10:
0 : No alarm occurs.
1 : P/S alarm No.245 occurs.
TCE When a tool length offset is specified in a rigid tapping or drilling
canned cycle, the axis to which the tool length offset applies is:
0 : Determined according to the specifications of tool length offset
C.
1 : The drilling axis.
NOTE
This parameter is valid when tool length offset C is
selected (bit 0 (TLC) of parameter No. 5001 = 1).