
B-64120EN/01 4.DESCRIPTION OF PARAMETERS
- 85 -
NOTE
1 Set parameter No.1620 to time constant T
1
used
for bell-shaped acceleration/deceleration in rapid
traverse, and set this parameter to time constant
T
2
.
For details of time constants T
1
and T
2
, see the
description of parameter No.1620.
2 When this parameter is set to 0, linear acceleration/
deceleration is applied in rapid traverse. The
setting in parameter No.1620 is used as a time
constant in linear acceleration/deceleration.
1622
Time constant of exponential acceleration/deceleration or bell-shaped
acceleration/deceleration after interpolation, or linear
acceleration/deceleration after interpolation in cutting feed for each axis
[Data type] Word axis
[Unit of data] ms
[Valid data range] 0 to 4000 (exponential acceleration/deceleration in cutting feed)
0 to 512 (linear or bell-shaped acceleration/deceleration after
interpolation in cutting feed)
Set the time constant used for exponential acceleration/deceleration in
cutting feed, bell-shaped acceleration/deceleration after interpolation
or linear acceleration/deceleration after interpolation in cutting feed
for each axis. Except for special applications, the same time constant
must be set for all axes in this parameter. If the time constants set for
the axes differ from each other, proper straight lines and arcs cannot
be obtained.
This parameter is valid for threading, irrespective of the
acceleration/deceleration type. For threading cycles G76 and G92
(G78 in the G code system B or C), this parameter is valid for
operations other than exponential acceleration/deceleration. (T series)
Speed
T
Time
Bell-shaped acceleration/deceleration after cutting feed interpolation
T : Total time. it is constant irrespective of feed rate.
(Time constant is constant).
The curve corresponds to that T
1
= T/2 and T
2
= T/2
set in parameter No.1620 and 1621.