
4.DESCRIPTION OF PARAMETERS B-64120EN/01
- 186 -
4.20 PARAMETERS OF SPINDLE CONTROL
#7 #6 #5 #4 #3 #2 #1 #0
3700 ESP ESV MSE NRF
[Data type] Bit
NRF The first move command (such as G00 and G01) after the serial
spindle is switched to Cs axis contouring control performs:
0 : Positioning after returning to the reference position.
1 : Normal positioning.
NOTE
When using the Cs axis establishment function,
this parameter is recommended to be set to 1.
MSE Rigid tapping synchronization error data output when bit 5 (ESV) of
parameter No. 3700 is set to 1 or when bit 7 (ESP) of parameter No.
3700 is set to 1 is:
0 : A synchronization error in the positional deviation. (equivalent
to DGN No. 456)
1 : A synchronization error in the machine position. (equivalent to
DGN No. 459)
ESV When bit 7 (ESP) of parameter No. 3700 is set to 1, rigid tapping
synchronization error data is:
0 : Not output to the servo system.
1 : Output to the servo system.
NOTE
Set this parameter as necessary when making
servo and spindle adjustments by using a servo
guide and so forth. After completing adjustments,
reset this parameter to 0.
ESP Rigid tapping synchronization error data is:
0 : Not output to the spindle.
1 : Output to the spindle.
NOTE
Set this parameter as necessary when making
servo and spindle adjustments by using a servo
guide and so forth. After completing adjustments,
reset this parameter to 0.