
4.DESCRIPTION OF PARAMETERS B-64120EN/01
- 194 -
0 : Not used.
1 : Used.
If a spindle gear of M type is selected, this function compares the
specified S value and the settings of parameters No. 3741 to No. 3743
and raises an alarm if the S value is greater.
If this function is used, specifying an S value larger than the settings
of parameters No. 3741 to No. 3743 causes P/S alarm 5310 to be
raised.
NOTE
This function cannot be used together with any of
bit 4 (GTT) of parameter No. 3706, constant
surface speed control, or multi-spindle control.
THB The threading start type is:
0 : Type A.
1 : Type B.
NOTE
When using PMC axis control, set this parameter to
1.
#7 #6 #5 #4 #3 #2 #1 #0
CSL
3710
CSL SGR
[Data type] Bit
SGR When method B is selected as the spindle gear switching method for a
tapping cycle (G84 or G74) (bit 3 (SGT) of parameter No. 3705 = 1),
gear switching method B is used for:
0 : Both tapping and rigid tapping.
1 : Rigid tapping only.
CSL In Cs contour control mode, fine acceleration/deceleration is disabled
for:
0 : An axis selected by the signal (CDFn <G0127>) issued from the
PMC. (n = 1 to 4)
1 : An axis for which interpolation is performed with the Cs contour
controlled axis (parameter No. 39n0). (n = 0 to 2)
#7 #6 #5 #4 #3 #2 #1 #0
3712 CSF
[Data type] Bit
CSF The Cs axis coordinate setup function is:
0 : Disabled.
1 : Enabled.
NOTE
When setting this parameter to 1, also set bit 5 of
parameter No. 4353 to 1.