
B–64113EN–1/01
2. PREPARATIONS FOR OPERATION
176
NOTE
1 Rapid traverse in automatic operation includes all rapid
traverses in canned cycle positioning, automatic reference
point return, etc., as well as the move command G00. Rapid
traverse in manual operation also includes rapid traverse in
reference position return.
2 Once rapid traverse has been selected, this signal remains
“1”, including during a stop, until another feedrate has been
selected and movement has been started.
[Classification] Output signal
[Function] Signals that cutting feed is being performed by automatic operation.
[Output condition] This signal is set to 1 in the following case:
– When cutting feed is being performed by automatic operation (cutting
feed for linear interpolation, circular interpolation, helical
interpolation, thread cutting, skip cutting, or cutting in canned cycle)
CAUTION
This signal is not set to ”1” in the feed hold state.
NOTE
This signal is set to ”1” even when the feedrate override is
0%, and even during interlock.
#7
F002
#6
CUT
#5 #4 #3 #2 #1
RPDO
#0
Cutting feed signal CUT
<F002#6>
Signal address