
B–64113EN–1/01
1. AXIS CONTROL
5
NOTE
1 With the T series, when G code system A is used, neither
U, V, nor W can be used as an axis name. Only when G code
system B or C is used, U, V, and W can be used as axis
names.
2 The same axis name cannot be assigned to more then one
axis.
3 The address used by the secondary auxilliary function
(address B with the T series or, with the M series, the
address specified in parameter No.3460) cannot be used as
an axis name.
4 With the T series, when address C or A is used for
chamfering, corner R, or direct drawing dimension
programming (when the CCR parameter (bit 4 of parameter
No.3405) is set to 1), addresses C or A cannot be used as
an axis name.
5 Only with the T series, address E can be used as an axis
name. Address E cannot be used with the M series. When
address E is used as an axis name, note the following:
– When G code system A is used, address E is always
assigned to an absolute command.
– When an equal–lead threading command (G32) is
issued in the FS10/11 tape format. Use address F to
specify the thread lead.
OPERATOR’S MANUAL
(M series) (B–64124EN)
II.2.2 NAMES OF AXES
OPERATOR’S MANUAL
(T series) (B–64114EN)
II.2.2 NAMES OF AXES
OPERATOR’S MANUAL
(M series) (B–64144EN)
II.2.2 NAMES OF AXES
OPERATOR’S MANUAL
(T series) (B–64134EN)
II.2.2 NAMES OF AXES
Reference item