B–64113EN–1/01
10. TOOL FUNCTIONS
703
Number Message Description
032 ILLEGAL OFFSET VALUE
IN G10
In setting an offset amount by G10 or
in writing an offset amount by system
variables, the offset amount was ex-
cessive.
5300 SET ALL OFFSET DATAS
AGAIN
After the inch/metric automatic con-
version function (OIM: Bit 0 of param-
eter No. 5006) for tool offset data is
enabled or disabled, all the tool offset
data must be reset. This message
reminds the operator to reset the
data.
If this alarm is issued, reset all the tool
offset data. Operating the machine
without resetting the data will result in
a malfunction.
Warning message Content
DATA IS OUT OF RANGE The value searched exceeds the permitted
range.
TOO MANY DIGITS The input value exceeds the permitted number of
digits.
Alarm and message